LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 317 (Fixed And MOVEABLE Windows) >> Repair Instructions >> Windshield Side Reveal Molding Replacement

Windshield Side Reveal Molding Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Window Side Reveal Molding
GM1669885Courtesy of GENERAL MOTORS CORP.
Windshield Side Reveal Molding Replacement

Callout Component Name

Preliminary Procedures

  1. Open the front door on the side the reveal molding is being serviced.
  2. Pull the door auxiliary weatherstrip up to the roof header.
  3. Remove the air inlet grille panel end cap.
1 Reveal Molding Nut
2 Windshield Side Reveal Molding
TIP:  Upon installation, tuck the bottom edge of the reveal molding under the end cap of the air inlet grille panel prior to the screw installation.
3 Windshield Side Reveal Molding Screw (Qty: 5)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
scientia non olet · About LEMON Manuals