LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 317 (Fixed And MOVEABLE Windows) >> Diagnostic Information and Procedures >> Power Windows Malfunction (RPO Z75) >> Component Testing

Component Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Rear Window Motor

  1. Ignition OFF, disconnect the harness connector at the appropriate window motor.
  2. Install a 25A fused jumper wire between one of the control terminals and 12V. Momentarily install a jumper wire between the other control terminal and ground. Reverse the jumper wires at least two times, the window motor should perform the UP and DOWN functions.
    • If it does not perform as specified, replace the window motor.
scientia non olet · About LEMON Manuals