LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 317 (Fixed And MOVEABLE Windows) >> Diagnostic Information and Procedures >> DTC B3821 or B3824 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the appropriate rear window switch.
  2. Ignition ON, enable the rear window switches by pressing the window lockout switch on the driver master control.
  3. Test for greater than 9 volts between the control circuit terminal D and ground.
    • If less than the specified range, test the control circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the BCM.
  4. If all circuits test normal, replace the rear window switch.
scientia non olet · About LEMON Manuals