Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Sliding Red CPA Away From Connector Lever

Courtesy of GENERAL MOTORS CORP.

Using your thumbs press down and slide the red CPA away from the connector lever.

Fig 2: Pressing Down On Locking Tab - Tyco/AMP Connectors (SIR)

Courtesy of GENERAL MOTORS CORP.

Using your thumb press down on the locking tab and move the lever to the released position.

Fig 3: Releasing Wire Dress Cover Locking Tabs

Courtesy of GENERAL MOTORS CORP.

Using terminal tool J-38125-11A or equivalent, release the wire dress cover locking tabs.

Fig 4: Pivoting Connector Wire Dress Cover

Courtesy of GENERAL MOTORS CORP.

Pivot connector wire dress cover while removing from the connector body.

Fig 5: Using Terminal Tool

Courtesy of GENERAL MOTORS CORP.

Using terminal tool J-38125-11A or equivalent, remove the TPA by lifting straight off the connector body.

Fig 6: Releasing Terminal Release Tool -- Tyco/AMP Connectors (SIR)

Courtesy of GENERAL MOTORS CORP.

Using terminal release tool J-38125-215A, place the tip of the tool on the outside edge next to the terminal and depress the lock tab and remove the rear of the connector body.