Terminal Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Tyco/AMP Connector

Courtesy of GENERAL MOTORS CORP.

Side view of connector.

Fig 2: Tyco/AMP Connector Top

Courtesy of GENERAL MOTORS CORP.

View of top of connector.

Locate the assist lever and lock on the top of the connector.

Fig 3: Depressing Lock

Courtesy of GENERAL MOTORS CORP.

While depressing the lock, pull the lever over and past the lock.

Fig 4: Component Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the connector from the component.

Fig 5: Releasing Locking Tabs

Courtesy of GENERAL MOTORS CORP.

Locate the dress cover locking tabs at the rear of the connector. Use a small flat-blade tool to release the locking tabs. Repeat this procedure for the other locking tab.

Fig 6: Sliding Inner Connector Out Of Connector Housing

Courtesy of GENERAL MOTORS CORP.

Once the locking tabs are unlocked, slide the inner connector out of the rear of the connector housing.

Fig 7: Releasing Terminals

Courtesy of GENERAL MOTORS CORP.

Use the J-38125-12A tool to release the terminals by pressing on the tang.
While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.
Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair) , Repairing Connector Terminals (Terminal Repair) procedure.
Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.