LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 315 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Power Mode Mismatch >> Component Testing

Component Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Ignition Switch

  1. Ignition OFF, disconnect the harness connector at the ignition switch.
  2. Verify the resistance between the terminals listed below match for each ignition switch position.
    • If not the specified value, replace the ignition switch.
Resistance Test

Ignition Switch Position Terminals 2 and 4 Terminals 3 and 4 Terminals 4 and 5 Terminals 4 and 6 Terminals 5 and 6
Off Key Out Infinite Infinite Infinite Infinite Infinite
Off Key IN Infinite Infinite < 5.0 Ω Infinite Infinite
Accessory Infinite < 5.0 Ω Infinite Infinite Infinite
Run < 5.0 Ω < 5.0 Ω Infinite Infinite < 5.0 Ω
Start < 5.0 Ω Infinite Infinite Infinite 1275-1325 Ω
scientia non olet · About LEMON Manuals