LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 315 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Kostal Connectors (Transmission) >> Terminal Removal Procedure

Terminal Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Connector And Lock
    GM1921876Courtesy of GENERAL MOTORS CORP.
  1. While depressing the lock, twist and remove the connector from the component.
    2. Fig 2: Terminal Position Assurance (TPA)
    GM1921872Courtesy of GENERAL MOTORS CORP.
  2. Locate the terminal position assurance (TPA).
    3. Fig 3: View Of TPA And Flat-Bladed Tool
    GM1921873Courtesy of GENERAL MOTORS CORP.
    NOTE:

    The TPA cannot be removed from the connector while there are terminals present in the connector body.

  3. Use a small flat-blade tool to push the TPA until it bottoms out.
    4. Fig 4: Releasing Terminals
    GM1921843Courtesy of GENERAL MOTORS CORP.
  4. Use the J-38125-28 tool to release the terminals by inserting the tool into the terminal cavity as shown in the graphic.
  5. While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.
  6. Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair) , Repairing Connector Terminals (Terminal Repair)  procedure.
scientia non olet · About LEMON Manuals