LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 315 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Delphi Connectors (Push To Seat) >> Terminal Insertion Procedure

Terminal Insertion Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. In order to reuse a terminal or lead assembly, refer to Wiring Repairs .
  2. Ensure that the cable seal is kept on the terminal side of the splice.
  3. Insert the lead from the back until it catches.
  4. Install the TPA, CPA, and/or the secondary locks.
scientia non olet · About LEMON Manuals