LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 315 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Delphi Connectors (Pull To Seat) >> Terminal Removal Procedure

Terminal Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

If the terminal is visibly damaged or is suspected of having a faulty connection, the terminal should be replaced.

Fig 1: Aligning Removal Tool
GM904718Courtesy of GENERAL MOTORS CORP.

Follow the steps below in order to repair pull-to-seat connectors:

  1. Remove the connector position assurance (CPA) device and/or the secondary lock.
  2. Disconnect the connector from the component or separate the connectors for in-line connectors.
  3. Remove the terminal position assurance (TPA) device.
  4. Review the connector end view to determine the proper test probe and release tool.
  5. Insert the release tool into the front of the connector body.
  6. Grasp the wire at the back of the connector body and gently push the terminal out the front of the connector body.
  7. Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair) , Repairing Connector Terminals (Terminal Repair)  procedure.
  8. Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.
scientia non olet · About LEMON Manuals