LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 315 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Delphi Connectors (Micro-Pack 100W) >> Terminal Insertion Procedure

Terminal Insertion Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

After the terminal is crimped to the wire perform the following procedure in order to replace Micro-Pack 100 terminals.

  1. Slide the new terminal into the correct cavity at the back of the connector.
  2. Push the terminal into the connector until it locks into place. The new terminal should be even with the other terminals. Ensure that the terminal is locked in place by gently pulling on the wire.
  3. To assemble the connector, reverse the Terminal Removal Procedure.
scientia non olet · About LEMON Manuals