LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 315 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC B0005 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the park enable PCB relay.
  2. Connect a test lamp between the park enable signal circuit and battery positive voltage.
  3. Ignition ON, transmission in PARK, verify the test lamp does not illuminate.
    • If the test lamp illuminates, test for a short to ground on the park enable signal circuit. If the circuit tests normal and the DTC is current, replace the BCM.
  4. If the circuit tests normal and the DTC is current, test or replace the park enable PCB relay.
scientia non olet · About LEMON Manuals