LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 314 (Wiring Systems And Power Management - Component Connector End Views - Mode Actuator Through Yaw Sensor) >> Component Connector End Views >> Tail Lamp Circuit Board - Right (Z75 with E52)

Tail Lamp Circuit Board - Right (Z75 with E52)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Tail Lamp Circuit Board - Right (Z75 with E52) Connector End View
GM1333935Courtesy of GENERAL MOTORS CORP.
Tail Lamp Circuit Board- Right (Z75 with E52)

Pin Wire Circuit Function
A 0.5 BN 2609 Right Rear Park Lamps Control
B 0.5 YE/BK 1335 Right Rear Stop/Turn Lamp Control
C 0.5 PK/BK 5357 Right Tail Lamp Outage Detection Signal
D 0.5 BK 1750 Ground
E 0.5 L-BU 20 Right Rear Stop/Turn Lamp Control (EXP)
0.5 L-BU 19 Right Rear Stop/Turn Lamp Control (except EXP)
Connector Part Information
  • Harness Type: Right Rear Lamp
  • OEM Connector: 12077591
  • Service Connector: 12117277
  • Description: 5-Way F Metri-Pack 150 Series, Sealed (BK)
Terminal Part Information
  • Terminated Lead: Service by Connector Assembly- 12117277
  • Release Tool: Pending
  • Diagnostic Test Probe: Pending
  • Terminal/Tray: Not Available
  • Core/Insulation Crimp: Not Available
scientia non olet · About LEMON Manuals