LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 314 (Wiring Systems And Power Management - Component Connector End Views - Mode Actuator Through Yaw Sensor) >> Component Connector End Views >> Seat Lumbar Switch - Passenger (AN3)

Seat Lumbar Switch - Passenger (AN3)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Seat Lumbar Switch - Passenger (AN3) Connector End View
GM73146Courtesy of GENERAL MOTORS CORP.
Seat Lumbar Switch - Passenger (AN3)

Pin Wire Circuit Function
A 3 OG 792 Passenger Seat Lumbar Up Switch Signal
B 3 D-BU 211 Passenger Seat Lumbar In Switch Signal
C 3 WH 210 Passenger Seat Lumbar Out Switch Signal
D - - Not Used
E 3 BK 1250 Ground
F 3 PK 793 Passenger Seat Lumbar Down Switch Signal
G 3 RD/WH 1440 Battery Positive Voltage
Connector Part Information
  • Harness Type: Passenger Seat
  • OEM Connector: 12052854
  • Service Connector: 15862656
  • Description: 7-Way F Metri-Pack 280 Series (BK)
Terminal Part Information
  • Terminated Lead: Service by Connector Assembly - 15862656
  • Release Tool: J-38125-11A
  • Diagnostic Test Probe: J-35616-4A (PU)
  • Terminal/Tray: 12015858/4
  • Core/Insulation Crimp: F/G
scientia non olet · About LEMON Manuals