LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 314 (Wiring Systems And Power Management - Component Connector End Views - Mode Actuator Through Yaw Sensor) >> Component Connector End Views >> Seat Adjuster Switch - Driver (AG1 without AN3 or AG1 with HP2)

Seat Adjuster Switch - Driver (AG1 without AN3 or AG1 with HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Seat Adjuster Switch - Driver (AG1 without AN3 or AG1 with HP2) Connector End View
GM556473Courtesy of GENERAL MOTORS CORP.
Seat Adjuster Switch- Driver (AG1 without AN3 or AG1 with HP2)

Pin Wire Circuit Function
A 3 D-GN 286 Driver Seat Front Vertical Motor Up Control
B 3 BK 1150 Ground
C 3 TN 285 Driver Seat Horizontal Motor Forward Control
D 3 RD/WH 5040 Battery Positive Voltage
E 3 YE 282 Driver Seat Rear Vertical Motor Up Control
F 3 L-GN 284 Driver Seat Horizontal Motor Rearward Control
G 3 L-BU 283 Driver Seat Rear Vertical Motor Down Control
H 3 D-BU 287 Driver Seat Front Vertical Motor Down Control
Connector Part Information
  • Harness Type: Driver Seat
  • OEM Connector: 15326924
  • Service Connector: 19153751
  • Description: 8-Way F GT 280 Series (BK)
Terminal Part Information
  • Terminated Lead: 13575756
  • Release Tool: J-38125-553
  • Diagnostic Test Probe: J-35616-4A (PU)
  • Terminal/Tray: 15304713/19
  • Core/Insulation Crimp: F/D
scientia non olet · About LEMON Manuals