LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 313 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Solenoid Cable Replacement (with TP2) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Mega Fuse Cover
    GM1702800Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  3. Remove the mega fuse cover.
    4. Fig 2: Battery Cable Components
    GM1702504Courtesy of GENERAL MOTORS CORP.
  4. Remove the starter solenoid cable nut (1) from the mega fuse stud.
  5. Remove the starter solenoid cable terminal (2) from the mega fuse stud.
  6. Open the starter solenoid cable cover at the positive battery terminal.
  7. Loosen the starter solenoid cable nut (5).
  8. Remove the starter solenoid cable from the positive battery terminal.
  9. Remove the starter solenoid cable clip (4) from the air conditioning (A/C) evaporator tube.
    10. Fig 3: Oil Pan Skid Plate And Bolts
    GM1698082Courtesy of GENERAL MOTORS CORP.
  10. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  11. For 1500 series vehicles, remove the oil pan skid plate bolts and plate.
    12. Fig 4: Oil Pan Skid Plate
    GM1698083Courtesy of GENERAL MOTORS CORP.
  12. For 2500 series vehicles, remove the front 2 oil pan skid plate bolts, loosen the rear 2 bolts and remove the skid plate.
    13. Fig 5: Starter Solenoid Cable Clip And Bolt
    GM1702990Courtesy of GENERAL MOTORS CORP.
  13. Remove the starter solenoid cable clip (1) from the wheelhouse panel.
  14. Remove the starter solenoid cable clip bolt (2) from the frame.
    15. Fig 6: Starter Solenoid Cable And Nut
    GM1699544Courtesy of GENERAL MOTORS CORP.
  15. Remove the starter solenoid cable nut (1) from the starter.
  16. Remove the starter solenoid cable (2) from the starter.
  17. Lower the vehicle.
    18. Fig 7: Starter Solenoid Cable
    GM1702991Courtesy of GENERAL MOTORS CORP.
  18. Remove the starter solenoid cable from the vehicle.
scientia non olet · About LEMON Manuals