LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 313 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Battery Jumper Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Mega Fuse Cover
    GM1702800Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  3. Remove the mega fuse cover.
    4. Fig 2: Generator Battery Jumper Cable
    GM1699546Courtesy of GENERAL MOTORS CORP.
  4. Remove the generator battery jumper cable to mega fuse nut (3).
  5. Remove the generator battery jumper cable terminal (4) from the mega fuse stud.
  6. Remove the generator battery jumper cable clip (2) from the air conditioning (A/C) evaporator tube.
  7. Remove the generator battery jumper cable clip (1) from the stud.
    8. Fig 3: Battery Jumper Cable Terminal, Nut And Bolt
    GM1702914Courtesy of GENERAL MOTORS CORP.
  8. Reposition the generator battery jumper cable boot (3).
  9. Remove the generator battery jumper cable nut (2) from the generator.
  10. Remove the generator battery jumper cable terminal (1) from the generator stud.
    11. Fig 4: Generator Battery Jumper Cable
    GM1702992Courtesy of GENERAL MOTORS CORP.
  11. Remove the generator battery jumper cable from the vehicle.
scientia non olet · About LEMON Manuals