LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 312 (Steering Wheel And Steering Column) >> Repair Instructions >> Upper Intermediate Steering Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    Failure to transfer the match marks may result in an off-center steering wheel after installation.

  1. If you are installing a new upper intermediate steering shaft, copy the match marks from the old component to the new component.
  2. Working inside the engine compartment, position the upper intermediate steering shaft in the vehicle.
    3. Fig 1: Upper Intermediate Shaft Pinch Bolt And Nut
    GM1701530Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  3. Align the match marks and connect the upper intermediate steering shaft to the steering column. Install the steering shaft coupling nut (1) and the bolt (2) to the steering column. Tighten the nut to 62 N.m (46 lb ft).
  4. Install the steering column seal. Refer to Steering Column Seal Replacement .
    5. Fig 2: Upper & Lower Intermediate Shafts And Components
    GM1701888Courtesy of GENERAL MOTORS CORP.
  5. Align the match marks and connect the upper intermediate steering shaft to the steering shaft coupling. Install the steering shaft coupling nut (1) and the bolt (2) to the steering shaft coupling. Tighten the bolt to 50 N.m (37 lb ft).
    6. Fig 3: Locking/Unlocking Steering Column
    GM333146Courtesy of GENERAL MOTORS CORP.
  6. Remove the J-42640  pin from the steering column lower access hole.
scientia non olet · About LEMON Manuals