LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 310 (Instrument Panel System Displays And Gauges) >> Diagnostic Information and Procedures >> Fuel Gauge Inaccurate or Inoperative (Single Tank) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the fuel level sensor.
  2. Ignition OFF, test for less than 1.0 Ω between the fuel level sensor low reference circuit terminal B and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Install a Signal Generator and Instrument Panel Tester between the signal circuit terminal C and ground.
  4. Ignition ON, vary the signal generator resistance between 40-250 Ω. Verify that the scan tool Fuel Tank Level Remaining parameter displays a range that varies between 5-95 percent as the signal generator resistance changes.
    • If not within the specified range, test the signal circuit for an open/high resistance. If the circuits test normal, replace the ECM.
  5. Vary the signal generator resistance between 40-250 Ω. Verify that the fuel gauge displays a range that varies between empty and full as the signal generator resistance changes.
    • If the gauge is incorrect, replace the IPC.
  6. If all circuits test normal, perform the fuel level sensor component test before replacing the fuel level sensor.
scientia non olet · About LEMON Manuals