LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 310 (Instrument Panel System Displays And Gauges) >> Diagnostic Information and Procedures >> DTC P2067 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the secondary fuel level sensor.
  2. Ignition ON, verify that the scan tool Fuel Tank Level Remaining parameter display is less than 4 percent.
    • If greater than the specified value, test the secondary signal circuit terminal C for a short to ground. If the circuit tests normal, replace the ECM.
  3. If all circuits test normal, test or replace the secondary fuel level sensor.
scientia non olet · About LEMON Manuals