LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Wiring Systems And Power Management) >> Repair Instructions >> Instrument Panel Electrical Center or Junction Block Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right side end panel.
  2. Push in the tabs in order to remove the fuse block.
    3. Fig 1: Right Instrument Panel Electrical Center Or Junction Block
    GM375032Courtesy of GENERAL MOTORS CORP.
  3. Pull out the fuse block out of the I/P in order to remove the retaining bolt.
  4. Loosen the bolt.
  5. Insert a screw driver between the wire harness block and fuse block in order to separate.
  6. Separate the fuse block from the I/P harness block.
  7. Remove the IP wiring harness block from the vehicle.
scientia non olet · About LEMON Manuals