LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Wiring Systems And Power Management) >> Repair Instructions >> Instrument Panel Electrical Center or Junction Block Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Left Instrument Panel Electrical Center Or Junction Block
    GM386487Courtesy of GENERAL MOTORS CORP.
  1. Remove the left side end panel.
  2. Remove the knee bolster. Refer to Driver Knee Bolster Panel Replacement .
  3. Disconnect all the wiring connectors from the fuse block.
  4. Remove all the fuses.
  5. Remove the turn signal relay from the back of the fuse block.
  6. From behind the fuse block, remove the retaining bolt.
  7. Insert a screw driver between the fuse block and the wire harness block to separate.
  8. Push on the retainers in order to remove the fuse block.
  9. Remove the fuse block from the vehicle.
scientia non olet · About LEMON Manuals