LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Wiring Systems And Power Management) >> Repair Instructions >> Ignition Lock Cylinder Case Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the ignition switch. Refer to Ignition and Start Switch Replacement .
  3. Remove the turn signal cancel cam. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement .
  4. Remove the park lock cable from the lock cylinder housing.
    5. Fig 1: View Of Lock Cylinder Housing TORX Screws
    GM1413838Courtesy of GENERAL MOTORS CORP.
  5. Remove 3 TORX® screws.
  6. Remove the lock cylinder housing from the steering column.
scientia non olet · About LEMON Manuals