Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Lock Cylinder Housing TORX Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install 3 TORX® screws into the lock cylinder housing.
Tighten: Tighten the TORX® screws to 7 N.m (62 lb in).
Install the turn signal cancel cam. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement .
Install the park lock cable into the lock cylinder housing.
Install the ignition switch. Refer to Ignition and Start Switch Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling .