LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Wiring Systems And Power Management) >> Diagnostic Information and Procedures >> Yazaki Connectors (16-Way) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. While depressing the lock, pull the two connector halves apart.
    Fig 1: Pulling Two Connector Halves Apart
    GM1709336Courtesy of GENERAL MOTORS CORP.
  2. Use a small flat-blade tool to very carefully push the terminal position assurance (TPA) towards the face of the connector on both sides of the connector.
    IMPORTANT: The TPA is fragile and may break if not done carefully.
    Fig 2: View Of The Male Connector Half & Female Terminals
    GM1709329Courtesy of GENERAL MOTORS CORP.
  3. View of the male half of the connector with female terminals.
    Fig 3: View Of The Female Half Of Connector With Male Terminals.
    GM1709335Courtesy of GENERAL MOTORS CORP.
  4. View of the female half of the connector with male terminals.
  5. Use the J 38125-215 tool to release the terminals by inserting the tool into the terminal release cavity. See the release tool cross reference in the Reference Guide of the J-38125  to ensure that the correct release tool is used.
    Fig 4: Using Removal Tool On Female Half Of Connector
    GM1709332Courtesy of GENERAL MOTORS CORP.
  6. View of the female half of the connector with male terminals.
    Fig 5: Using Removal Tool On Male Half Of Connector
    GM1709331Courtesy of GENERAL MOTORS CORP.
  7. View of the male half of the connector with female terminals.
  8. While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.
scientia non olet · About LEMON Manuals