LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Wiring Systems And Power Management) >> Diagnostic Information and Procedures >> Bosch Connectors (2.8 JPT) >> Terminal Removal Procedure

Terminal Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull out the slider on the connector position assurance (CPA) until it is at the end of its travel.
  2. Disconnect the connector from the component.
  3. Remove the wire dress cover, if necessary.
  4. Push the wire side of the terminal that is being removed toward the connector and hold it in position.
    5. Fig 1: Removing Bosch Connector Terminals (2.8 JPT)
    GM1445490Courtesy of GENERAL MOTORS CORP.
  5. Insert the J 38125-557 (GM P/N 12122378) into the 2 cavities on each side of the terminal at the front of the connector and push until you feel the tool disengage the terminal retainers. See the release tool cross reference in the Reference Guide of the J-38125  to ensure that the correct release tool is used.
  6. Carefully pull the terminal out of the connector. Always remember never use force when pulling a terminal out of a connector. If the terminal is difficult to remove, repeat the entire procedure.
scientia non olet · About LEMON Manuals