LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 309 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Heater Inlet Hose Replacement (Non-HP2) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Inlet And Outlet Heater Hoses
    GM363118Courtesy of GENERAL MOTORS CORP.
  1. Install the inlet heater hose.
    2. Fig 2: Inlet Heater Hose At Engine
    GM363237Courtesy of GENERAL MOTORS CORP.
  2. Install the inlet heater hose to the water pump.
    3. Fig 3: Quick-Connect Fittings
    GM21855Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:

    Firmly push the quick connect onto the heater core pipe until you hear an audible click.

  3. Connect the heater hose to the heater core.
  4. Install the heater and surge tank hoses to the mounting clip.
  5. Install the air intake tube.
  6. Fill the cooling system. Refer to Cooling System Draining and Filling (Static Fill) .
scientia non olet · About LEMON Manuals