Auxiliary Blower Motor Replacement (Standard Wheelbase)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Blower Motor Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the right rear quarter trim panel. Refer to Rear Quarter Trim Panel Replacement - Right Side (Extended Wheelbase) , Rear Quarter Trim Panel Replacement - Right Side (Standard Wheelbase) . Disconnect the blower motor electrical connector.
1	Locking Tab (Qty: 2) Procedure Remove one attaching screw securing blower motor if applicable Carefully pull back locking tabs on blower motor assembly.
2	Auxiliary Blower Motor Assembly Procedure Rotate blower motor counterclockwise to remove.

Callout

Component Name

Preliminary Procedure

Remove the right rear quarter trim panel. Refer to Rear Quarter Trim Panel Replacement - Right Side (Extended Wheelbase) , Rear Quarter Trim Panel Replacement - Right Side (Standard Wheelbase) .
Disconnect the blower motor electrical connector.

Locking Tab (Qty: 2)

Procedure

Remove one attaching screw securing blower motor if applicable
Carefully pull back locking tabs on blower motor assembly.

Auxiliary Blower Motor Assembly
Procedure
Rotate blower motor counterclockwise to remove.