Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the A/C compressor (2) to the bracket (1) through the fender well. Insert the mounting bolt (3) into the lower right mounting boss before installing the A/C compressor.
- Install the A/C compressor to the bracket. Insert the mounting bolt into the lower right mount before installing the A/C compressor.
- Install the A/C compressor mounting bolts and tighten to 50 N.m (37 lb ft).
- Connect the electrical connector to the A/C compressor.
- Install the A/C discharge hose to the compressor using new sealing washers. Refer to Air Conditioning System Seal Replacement .
- Install the A/C discharge hose bolt to the A/C compressor and tighten to 16 N.m (12 lb ft).
- Install the A/C suction hose to the compressor using new sealing washers. Refer to Air Conditioning System Seal Replacement .
- Install the A/C suction hose bolt to the A/C compressor and tighten to 16 N.m (12 lb ft).
- Install the A/C drive belt. Refer to Air Conditioning Compressor Belt Replacement (V8) . If LC9 or LMG engine, Refer to Air Conditioning Compressor Belt Replacement (V8) .
- Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging (Non-HP2) , Refrigerant Recovery and Recharging (HP2) .
- Install the air cleaner resonator outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
- Leak test the fittings of the component using the J 39400-A .
CAUTION:
Refer to Fastener Caution .