LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 309 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement (Non-HP2) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: A/C High Pressure Recirculation Switch
    GM1769180Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  1. Install the A/C refrigerant pressure sensor (1).

    Tighten 

    Tighten the switch to 6 N.m (53 lb in).

  2. Connect the electrical connector to the A/C refrigerant pressure sensor.
  3. Leak test the fittings of the components using the J 39400-A .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals