LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 308 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Park Brake Cables At Equalizer Bar
    GM1471613Courtesy of GENERAL MOTORS CORP.
  1. Ensure the park brake is released.
  2. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Disconnect the left rear park brake cable (3) from the equalizer on the intermediate park brake cable (1).
    5. Fig 2: Park Brake Cable And Mounting Bracket
    GM363839Courtesy of GENERAL MOTORS CORP.
  5. Remove the park brake cable from the mounting bracket by depressing the locking tabs.
    6. Fig 3: Park Brake Cable, Shock Absorber Bracket And Bolt - Left Rear (w/o NYS)
    GM555965Courtesy of GENERAL MOTORS CORP.
  6. Remove the nut and bolt securing the park brake cable to the rear axle housing bracket (2500 series).
  7. Release the park brake cable from the park brake cable guides on the vehicle frame.
    8. Fig 4: Park Brake Cable & Actuator Lever
    GM1688693Courtesy of GENERAL MOTORS CORP.
  8. Remove the park brake cable from the actuator lever.
  9. Remove the park brake cable from the backing plate by depressing the locking tabs.
  10. Remove the park brake cable.
scientia non olet · About LEMON Manuals