LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 308 (Parking Brake System) >> Repair Instructions >> Parking Brake Indicator Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Park Brake Warning Lamp Switch Mounting Bolt
    GM913316Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake warning lamp switch.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the park brake warning lamp switch bolt and tighten to 3 N.m (27 lb in).
    3. Fig 2: Park Brake Warning Lamp Switch Electrical Connector
    GM606395Courtesy of GENERAL MOTORS CORP.
  3. Connect the park brake warning lamp switch electrical connector.
  4. Install the left side instrument panel electrical center/junction block. Refer to Instrument Panel Electrical Center or Junction Block Replacement - Left Side .
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals