To Open

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Opening the sunroof can be done from any position between fully closed and partially open. To open the sunroof glass, press and hold the sunroof switch to the first rearward position. This will apply the sunroof switch low reference circuit to the sunroof switch open vent signal circuit (12-volt reference) input, pulling the reference voltage to 0 volts. The constant low (0 volts) input to the sunroof module indicates an open request. Once the open has been initiated, the sunroof motor/module assembly will drive the motor in the open direction, slightly lowering the rear edge of the sunroof glass, then sliding open with the sunshade, allowing the wind deflector to raise upward. The sunroof glass will continue to open until the sunroof motion is terminated by either:

The sunroof glass reaches the full open position.
Releasing of the sunroof switch. The sunroof may be left in any position between fully open and fully closed.