Inflatable Restraint Seat Position Sensor Replacement (without HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inflatable Restraint Seat Position Sensor (without HP2)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: Refer to SIR Warning . Preliminary Procedures Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling . Remove the drivers seat. Refer to Front Seat Replacement - Bucket (without HP2) , Front Seat Replacement - Bucket (with HP2) .
1	Inflatable Restraint Seat Position Sensor Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 3 N.m (25 lb in)
2	Inflatable Restraint Position Sensor Assembly Procedure Disconnect the electrical connector.

Callout

Component Name

WARNING:

Refer to SIR Warning .

Preliminary Procedures

Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
Remove the drivers seat. Refer to Front Seat Replacement - Bucket (without HP2) , Front Seat Replacement - Bucket (with HP2) .

Inflatable Restraint Seat Position Sensor Screw (Qty: 2)

CAUTION:

Refer to Fastener Caution .

Tighten
3 N.m (25 lb in)

Inflatable Restraint Position Sensor Assembly
Procedure
Disconnect the electrical connector.