LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 304 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> Air Bag Indicator Circuit Malfunction (Driver) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, verify the SDM Battery Voltage Signal parameter is 9-16 volts.
  2. Ignition OFF, monitor the IPC, ignition ON. The SIR warning indicator should flash then turn OFF.
    • If the SIR warning indicator continually flashes, program the SDM.
    • If the SIR warning indicator remains on steady, test for DTCs and refer to Diagnostic Trouble Code (DTC) List - Vehicle . If no DTC is current, proceed to the next step.
  3. Perform the Display Test in Instrument Panel Cluster/Special Functions. The Air Bag indicator should turn ON and OFF as commanded.
    • If the air bag indicator does not illuminate as expected, replace the IPC.
  4. If all circuits test normal, replace the SDM.
scientia non olet · About LEMON Manuals