LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 301 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Rear Seat Riser Finish Cover Replacement (Tahoe/Yukon/Escalade w/Split Bench)

Rear Seat Riser Finish Cover Replacement (Tahoe/Yukon/Escalade w/Split Bench)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Seat Riser Finish Covers (Tahoe/Yukon/Escalade w/Split Bench)
GM1685303Courtesy of GENERAL MOTORS CORP.
Rear Seat Riser Finish Cover Replacement (Tahoe/Yukon/Escalade w/Split Bench)

Callout Component Name

Preliminary Procedures

  1. Flip and fold the rear seat forward.
  2. Remove the rear seat floor filler trim cover.
1 Rear Seat Riser Finish Cover Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Rear Seat Riser Finish Cover (Qty: 2)
3 Rear Seat Riser Finish Cover (Qty: 2)
scientia non olet · About LEMON Manuals