LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 301 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Driver or Passenger Seat Lumbar Support Actuator Replacement (with HP2)

Driver or Passenger Seat Lumbar Support Actuator Replacement (with HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Driver Or Passenger Seat Lumbar Support Actuator (With HP2)
GM1966908Courtesy of GENERAL MOTORS CORP.
Driver or Passenger Seat Lumbar Support Actuator Replacement (with HP2)

Callout Component Name

Preliminary Procedure

  1. Remove the front seat back cushion cover and pad. Refer to Driver or Passenger Seat Back Cushion Cover and Pad Replacement (with HP2) , Driver or Passenger Seat Back Cushion Cover and Pad Replacement (without HP2) .
  2. Remove the front seat cushion cover and pad. Refer to Seat Cushion Trim Cover and Pad Replacement (without HP2) , Seat Cushion Trim Cover and Pad Replacement (with HP2) .
1 Front Seat Lumbar Support Actuator Assembly Screw
CAUTION:

Refer to Fastener Caution .


TIP:  Twist actuator to unlock it from seat front once screw is removed.
Tighten 
3 N.m (27 lb in)
2 Front Seat Lumbar Support Actuator Assembly

Procedure

  1. Remove the actuator assembly from the seat cushion frame.
  2. Note the routing of the actuator assembly for installation.
  3. Remove the actuator assembly from the seat back cushion frame and lumbar support.
scientia non olet · About LEMON Manuals