3rd Row Seat Back Latch Cable with Pull Handle Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: 3rd Row Seat Back Latch Cable with Pull Handle

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the rear seat. Refer to 3rd Row Seat Replacement (Suburban/Yukon XL) , 3rd Row Seat Replacement (Tahoe/Yukon/Escalade) . Remove the rear seat cushion trim covers. Refer to Rear Seat Number 2 Cushion Panel Replacement (AS3) , Rear Seat Number 2 Cushion Panel Replacement (AW2) .
1	Rear Seat Latch Release Handle Refer to Rear Seat Latch Release Handle Replacement (Rear No. 2) .
2	Rear Seat No. 2 Back Cushion Latch Nut (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 9 N.m (80 lb in)
3	Rear Seat No. 2 Back Cushion Latch Bolt (Qty: 2) Tighten 9 N.m (80 lb in)
4	Rear Seat No. 2 Back Cushion Latch TIP: Release the latch cables from the seat, note the locations for installation.