LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 300 (Interior Trim And Interior Paneling) >> Repair Instructions >> Rear Side Door Window Garnish Molding Replacement

Rear Side Door Window Garnish Molding Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Side Door Window Garnish Molding And Retainers
GM1674926Courtesy of GENERAL MOTORS CORP.
Rear Side Door Window Garnish Molding Replacement

Callout Component Name
Preliminary Procedures 
Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Extended Wheelbase) , Rear Side Door Trim Panel Replacement (Standard Wheelbase) .
1 Rear Side Door Window Garnish Molding Retainer (Qty: 7)
2 Rear Side Door Window Garnish Molding
  1. Install the 2 lower clips to the window flange between the corners.
  2. Install the 2 side clips to the window flange between the corners.
  3. Install the remaining 3 clips around the window flange.