Front Bumper Fascia Support Replacement (Chevrolet HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Bumper Fascia Support (Chevrolet HP2)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the front fascia. Refer to Front Bumper Fascia Replacement (Yukon) , Front Bumper Fascia Replacement (Escalade) , Front Bumper Fascia Replacement (Tahoe) , Front Bumper Fascia Replacement (Avalanche) , Front Bumper Fascia Replacement (Z71) .
1	Front Bumper Fascia Support Bolt (Qty: 8) CAUTION: Refer to Fastener Caution . Tighten 7 N.m (62 lb in)
2	Front Bumper Fascia Support Procedure Disconnect any electrical connectors. Transfer parts as needed.

Callout

Component Name

Preliminary Procedure
Remove the front fascia. Refer to Front Bumper Fascia Replacement (Yukon) , Front Bumper Fascia Replacement (Escalade) , Front Bumper Fascia Replacement (Tahoe) , Front Bumper Fascia Replacement (Avalanche) , Front Bumper Fascia Replacement (Z71) .

Front Bumper Fascia Support Bolt (Qty: 8)

CAUTION:

Refer to Fastener Caution .

Tighten
7 N.m (62 lb in)

Front Bumper Fascia Support

Procedure

Disconnect any electrical connectors.
Transfer parts as needed.