LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 298 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Door Opening Weatherstrip Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Pinch-Weld Flange Weatherstrip (Rear Door Opening)
    GM686586Courtesy of GENERAL MOTORS CORP.
  1. Align the weatherstrip to the door opening with the 2 dots positioned on the upper right and left side.
  2. Align the weatherstrip to the door opening with the bond joint positioned at the lower center of the door opening.
  3. Install the weatherstrip to the pinch-weld flange. Ensure that the weatherstrip is fully seated.
scientia non olet · About LEMON Manuals