LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 298 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Endgate Adjustment >> Adjustment Procedure

Adjustment Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Endgate Adjustment Points
GM1855768Courtesy of GENERAL MOTORS CORP.
  1. With the endgate closed, determine the amount of adjustment will be needed.
  2. If adjustment is necessary, remove the endgate. Refer to Endgate Replacement (Avalanche/Escalade EXT) .
  3. Mark the position of the hinges with a grease pencil.
    4. NOTE:

    Use a screwdriver to move the adjustment hinge.

  4. Loosen the endgate bolts and adjust the endgate hinges by moving the hinges in the following directions.
    • Upward or downward
    • Inward or outward
  5. Reinstall the endgate and determine if any further adjustments are needed.
    6. CAUTION:

    Refer to Fastener Caution .

  6. When the proper adjustments are set, tighten the hinge bolts to 40 N.m (30 lb ft).
scientia non olet · About LEMON Manuals