LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 298 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Cargo Box Stowage Box Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Body Side Inner Panel Bolts And Cargo Box/Stowage Box
    GM1708945Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  1. Install the cargo box stowage box (2) to the vehicle and tighten to 9 N.m (80 lb in).
  2. Install the cargo tie-down rings and bolts to the body side inner panel and tighten to 9 N.m (80 lb in).
  3. Install the cargo box stowage lid assembly. Refer to Cargo Box Stowage Box Lid Replacement .
  4. Install the lamp socket to the pickup box side courtesy lamp assembly.
  5. Install the assist handle. Refer to Cargo Box Stowage Box Handle Replacement (Avalanche) .
  6. Install the rear compartment cover assembly. Refer to Cargo Box Front Cover, Center Cover, and Rear Cover Replacement .
scientia non olet · About LEMON Manuals