LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 298 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Cargo Box Stowage Box Lid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the endgate.
  2. Remove the cargo box cover assembly. Refer to Cargo Box Front Cover, Center Cover, and Rear Cover Replacement .
  3. Remove the assist handle. Refer to Cargo Box Stowage Box Handle Replacement (Avalanche) .
  4. Remove the top drain grate.
  5. Remove the cargo box bridge side inner panel. Refer to Cargo Box Bridge Side Inner Panel Replacement (Escalade EXT) , Cargo Box Bridge Side Inner Panel Replacement (Avalanche) .
    6. Fig 1: Cargo Stowage Box
    GM1708946Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolt (2) from inside the cargo box stowage lid assembly.
  7. Remove the bolts (1) from the top of the stowage lid.
  8. Remove the cargo box stowage box water run channel.
  9. Remove the cargo box from the vehicle.
scientia non olet · About LEMON Manuals