LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 298 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Cargo Box Stowage Box Lid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Cargo Stowage Box
    GM1708946Courtesy of GENERAL MOTORS CORP.
  1. Position the cargo box stowage lid (3) to the vehicle.
    2. NOTE:

    Ensure that the feather edge is properly sealed to the glass and side panels.

  2. Install the cargo box water run channel.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the bolts to the cargo box stowage lid (1) and tighten to 9 N.m (80 lb in).
  4. Install the bolt inside the cargo box stowage lid assembly (2) and tighten to 9 N.m (80 lb in).
  5. Install the cargo box bridge side inner panel. Refer to Cargo Box Bridge Side Inner Panel Replacement (Escalade EXT) , Cargo Box Bridge Side Inner Panel Replacement (Avalanche) .
  6. Install the assist handle. Refer to Cargo Box Stowage Box Handle Replacement (Avalanche) .
  7. Install the cargo box cover assembly. Refer to Cargo Box Front Cover, Center Cover, and Rear Cover Replacement .
  8. Close the endgate.
scientia non olet · About LEMON Manuals