Cargo Box Bridge Cross Bar Replacement (Escalade EXT)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cargo Box Bridge Cross Bar

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Ensure headlamp switch is in the OFF position. Remove rear compartment cover assembly. Refer to Cargo Box Front Cover, Center Cover, and Rear Cover Replacement .
1	Cargo Box Bridge Center Panel Screw (Qty: 6) CAUTION: Refer to Fastener Caution . Tighten 7 N.m (62 lb in)
2	Cargo Box Bridge Center Panel Assembly Disconnect electrical connector. When re-installing panel assembly, lubricate panel grommet prior to seating. If replacing panel assembly, transfer high mounted stop lamp. Refer to High Mount Stop Lamp Replacement (Avalanche) , High Mount Stop Lamp Replacement (Yukon) , High Mount Stop Lamp Replacement (Escalade) , High Mount Stop Lamp Replacement (Yukon Two-mode Hybrid) .

Callout

Component Name

Preliminary Procedures

Ensure headlamp switch is in the OFF position.
Remove rear compartment cover assembly. Refer to Cargo Box Front Cover, Center Cover, and Rear Cover Replacement .

Cargo Box Bridge Center Panel Screw (Qty: 6)

CAUTION:

Refer to Fastener Caution .

Tighten
7 N.m (62 lb in)

Cargo Box Bridge Center Panel Assembly

Disconnect electrical connector.
When re-installing panel assembly, lubricate panel grommet prior to seating.
If replacing panel assembly, transfer high mounted stop lamp. Refer to High Mount Stop Lamp Replacement (Avalanche) , High Mount Stop Lamp Replacement (Yukon) , High Mount Stop Lamp Replacement (Escalade) , High Mount Stop Lamp Replacement (Yukon Two-mode Hybrid) .