Tail Lamp Replacement (Cadillac)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Tail Lamp Replacement (Cadillac)
| Callout | Component Name |
|---|---|
| Preliminary Procedure Open the liftgate in order to access the tail lamp assembly screws. |
|
| 1 | Tail Lamp Assembly Screw (Qty: 2)
CAUTION:
Refer to Fastener Caution . Tighten 2 N.m (18 lb in) |
| 2 | Tail Lamp Assembly Locator Pin (Qty: 2) TIP: Upon tail lamp removal, some effort is needed to disengage the locating pins from the rear body panel retainer nuts. |
| 3 | Tail Lamp Retainer (Qty: 2) |
| 4 | Tail Lamp Wiring Harness Assembly Connector |
| 5 | Tail Lamp Assembly TIP: Upon installation of the tail lamp, push inward on the lamp in order to seat the 2 locator pins into the retainer nuts. |