LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 297 (Lighting System) >> Repair Instructions >> Stop Lamp Switch Replacement (With Adjustable Pedals) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply the park brake.
  2. Remove the driver knee bolster. Refer to Knee Bolster Replacement (Except Cadillac) , Knee Bolster Replacement (Cadillac) .
  3. Disconnect the stoplamp switch electrical connector.
    4. Fig 1: Brake Booster Pushrod Retainer Bolt
    GM1892143Courtesy of GENERAL MOTORS CORP.
  4. Remove the power vacuum brake booster pushrod retainer bolt (1).
    5. Fig 2: Brake Booster Pushrod Retainer
    GM1892145Courtesy of GENERAL MOTORS CORP.
  5. Remove the power vacuum brake booster pushrod retainer (1).
    6. Fig 3: Stoplamp Switch
    GM1892146Courtesy of GENERAL MOTORS CORP.
  6. Slide the power vacuum brake booster pushrod off of the brake pedal pin and remove the stoplamp switch (1).
scientia non olet · About LEMON Manuals