Front Fog Lamp Replacement (Tahoe, Avalanche)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Fog Lamp Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove either the LF or RF wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side , or Front Wheelhouse Liner Replacement - Right Side . Disconnect the electrical bulb socket from the lamp. From the inside of the front bumper fascia, using a blunt instrument, push outward on the 2 upper mounting studs for the fog lamp. Using the same blunt instrument, push outward on the lower adjustment screw for the fog lamp.
1	Forward Lamp Harness Electrical Connector TIP: Disconnect the electrical bulb socket from the lamp.
2	Fog Lamp Assembly TIP: Aim the fog lamps after the installation of the fog lamps. Refer to Fog Lamp Aiming (Tahoe/Yukon) .
3	Fog Lamp Upper Retainer (Qty: 2) TIP: Secure the retainer into the front bumper fascia prior to re-installing the fog lamp assembly.
4	Fog Lamp Adjuster Retainer TIP: Ensure the lower vertical tab on the retainer aligns with the slot in the front bumper fascia.