LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 297 (Lighting System) >> Diagnostic Information and Procedures >> Hazard Lamps Malfunction >> Circuit/System Description

Circuit/System Description

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

The hazard switch signal circuit is referenced from battery voltage by the BCM. When the hazard switch is activated, the signal circuit is grounded through the switch and the signal circuit voltage goes low. The BCM then sends an ON-OFF voltage signal through the fuses to the appropriate turn signal and side repeater (export only) lamps or to all of the turn signal fuses for hazard operation.

scientia non olet · About LEMON Manuals