LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 295 (Wiper System And Washer System) >> Repair Instructions >> Windshield Washer Hose Replacement

Windshield Washer Hose Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Windshield Washer Hose
GM1669975Courtesy of GENERAL MOTORS CORP.
Windshield Washer Hose Replacement

Callout Component Name

Preliminary Procedures

  1. Open the hood.
  2. Remove the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side .
  3. Disconnect the washer hose from the washer pump spout.
1 Windshield Washer Hose Retainer Clip
2 Windshield Washer Nozzle Hose
TIP:  Disconnect the hose at the left rear fender flange.
3 Windshield Washer Pump Hose Assembly
TIP:  Route the new hose in the same location as the old hose was removed from.